How to manage and delete commands on the HTR8 Remote?

The HTR 8 can store learned, copied, and default library commands on any key. Default library commands are the pre-programmed NAD codes, such as the native T 778 commands on the [AMP] “page.”

You can delete commands in layers, reverting back to the default library command on any key, thereby removing learned commands, punched-through functions, and copied keys.

Note: Default library commands cannot be deleted, so using Delete Mode will not cause any irreparable changes.

Delete Mode

Note: The Learn LED is located between the ON and OFF buttons.

To Enter Delete Mode:

1. Activate Delete Mode: Simultaneously press and hold for 3 seconds both the required key’s DEVICE SELECTOR key and the [RTN] key, until the Learn LED turns Green.
2. Select Function Key: Press the function key whose command you want to delete. The Learn LED flashes, and the number of flashes indicates which type of function has become active (see table below).
3. Exit Delete Mode: Press the active DEVICE SELECTOR key again to exit Delete Mode.

Note: You can delete multiple function-key commands on the same DEVICE SELECTOR “page.” However, to delete commands from more than one DEVICE SELECTOR page, you must exit Delete Mode and then re-enter it on the required page.