HTR 8 can be reset to its factory state, deleting all learned commands, copied/punched-through keys, macros, and other setup information — reverting all keys to their pre-programmed library commands.
To perform a factory reset of the HTR8 remote:
Note: The Learn LED is located between the ON and OFF buttons.
- Simultaneously press and hold the HTR 8’s [ON] and [RTN] keys for 10 seconds; the Learn LED will begin flashing green.
- Release [ON] and [RTN] before the second flash completes*; the Learn LED will turn red, indicating that the remote has been reset.
*Note: You should release [ON] and [RTN] before the second flash ends, or the unit will not reset. If this occurs, repeat the entire procedure.