The HTR 10's key illumination can be set to remain lit for 0-9 seconds. The default value is 2 seconds.
Notes:
- Key illumination is activated when you press any HTR 10 key.
- If the HTR 10 senses movement, key illumination is activated without pressing a key. Shaking the HTR 10 also activates key illumination.
- Key illumination is the biggest drain on the HTR 10’s batteries. Setting a short key illumination timeout will significantly extend battery life; turning it off completely (set to 0 seconds) will extend it even further.
Adjust Illumination Timeout
Note: The Learn LED is located between the ON and OFF buttons.
To adjust the illumination timeout:
- Enter Illumination Setting Mode: Simultaneously press and hold for 3 seconds both the HTR 10’s [INFO] key and one of the digit keys [0-9]. The digit you press corresponds to the desired timeout duration in seconds.
- Confirmation: The Learn LED will flash twice to confirm the new setting.
Note: Setting the illumination timeout to zero will prevent the illumination from turning on at all.
Configure Key Illumination
| Key to press (for 3 seconds) |
Mode |
| [INFO] + Digit Key [0]..to..[9] | Adjust the key illumination timeout by pressing the digit key for the required number of seconds. Setting it to zero turns off the key illumination completely. |
| [INFO] + [OFF] | Disable the light sensor. Key illumination will turn on with any key press. |
| [INFO] + [ON] | Enable the light sensor. |
| [INFO] + [ENTER] | Set the light sensor threshold to the current light level. |
| [INFO] + [↩] | Restore all key illumination settings to the defaults. |