The M17/M33's Sleep Mode automatically shifts the unit to Standby mode after a set number of minutes.
Configure Sleep Mode
To configure the Sleep Timer on M17/M33, perform the following steps:
- In the HTRM 2 remote, press the DEVICE SELECTOR – [AMP] button.
- Pressing the [RTN-SLEEP] button on the HTRM 2 once displays the current sleep timer setting on the front panel Vacuum Fluorescent Display (VFD).
- Pressing the [RTN-SLEEP] button a second time within three seconds adjusts the timer in 15-minute increments (maximum sleep time configurable – 90 minutes), prompting the M17/M33 to enter Standby mode when the timer runs out.
Cancel Sleep Mode
To turn off sleep mode, keep pressing the HTRM 2’s [RTN-SLEEP] button until "Sleep Off" appears on the VFD. Alternatively, switching the M17/M33 to Standby mode using either the HTRM 2’s OFF button or the M17/M33’s STANDBY button will also cancel the sleep mode.
Note
- Update the M33 to the recent BluOS firmware (BluOS 3.14.2 or latest) to access the above feature.