The SR 10 remote control handset manages the key functions of the C 3050 and can control up to four devices. It operates at a range of up to 23 feet (7 meters). To power the remote, insert two AA batteries into the compartment on the back, ensuring they are correctly oriented as indicated on the base of the compartment.
Notes:
- Function buttons on the SR 10 that are not discussed, designated, or highlighted are not applicable or functional for the specific device.
- The LED indicator between the ON and OFF buttons will flash blue whenever a control button is pressed.
To initiate the following C 3050 remote control commands, select AMP from the DEVICE SELECTOR buttons:
| 1 |
ON/OFF |
The SR 10 remote has separate ON and OFF buttons. Press ON to switch the C 3050 from Standby to operating mode. Press OFF to switch to Standby mode. | ||||||||||
| 2 | DEVICE SELECTOR |
A Device Selector button determines which component the SR 10 will command; it does not perform any function on the C 3050. Press the desired Device Selector button to direct the applicable buttons to a “page” of commands relevant to the selected device. After selecting a Device, press the corresponding SR 10 control buttons applicable to the selected Device. |
||||||||||
| 3 |
MUTE |
Press the MUTE button to temporarily switch off the sound to the speakers and headphones. MUTE mode is indicated by “Mute” shown on the front panel display. Press MUTE again to restore sound. Adjusting the volume level via the SR 10 or the front panel volume knob will automatically release the mute function. |
||||||||||
| 4 |
VOL [⯊/⯋] |
Press [⯊/⯋] to increase or decrease the volume level. Release the button when the desired level is reached. |
||||||||||
| 5 |
SOURCE [⯊/⯋] |
Toggle through Source input selections. If the optional MDC2 BluOS D module is installed, the Source selections will include sources incorporated with the MDC2 BluOS D module. |
||||||||||
| 6 |
EQ |
With the optional MDC2 BluOS D installed and Dirac Live calibration completed, use EQ to select available saved Dirac Filter settings. |
||||||||||
| 7 |
NUMERIC BUTTONS |
The numeric buttons allow for direct selection of Source input. Press the corresponding number button to directly select a Source: | ||||||||||
|
||||||||||||
| 8 |
BRIGHTNESS |
Adjust, turn off, or restore the display brightness of the SOURCE INPUT and VOLUME LEVEL LED indicators. There are six brightness levels when toggling the DIM button: 0 is off, and 5 is the brightest. |
||||||||||
| 9 |
(Applicable only if the optional MDC2 BluOS D is installed) With the optional MDC2 BluOS D installed and while at BluOS Source, select: |
|||||||||||
| [⏵] | Skip back to the beginning of the current song. | |||||||||||
| [⏮] | Skip back to the beginning of the current song. | |||||||||||
| [⏭] | Skip forward to the next song. | |||||||||||