You can enable or disable a source using this option. This is particularly useful if only a few sources are used regularly, allowing you to directly select the source from the front panel and bypass unused sources.
Additionally, if you have installed both the optional MDC HDM 2 and MDC BluOS modules, you will need to disable two or more sources to make room for the corresponding sources from both modules on the SR9 Remote Control's Input Selector buttons. Learn More.
Enable or disable Source:
To enable or disable a Source in the C368 / C388, perform the following steps on the front panel:
Front Panel | |
Use the navigation [] buttons to go through menu options and selections. The middle round button is designated as the [ENTER] button.
|
- Press the [◠] Navigation button on the C368 / C388 once or repeatedly until "Source Setup" is highlighted.
- Press [ENTER] to open the Source Setup menu.
- Use the [] Navigation buttons to navigate to the required source.
- Press [ENTER] to select the required source. The Enabled screen for the selected source will be displayed.
- Press [ENTER] again to display Yes or No.
- Use the [] Navigation buttons to select Yes or No:
Yes: Enable the selected source.
No: Disable the selected source. - Press [◠] multiple times to save the settings and return to the Source screen accessed before Step 1.